F-2L single layer glass reactor product introduction
F-2L single-layer glass reactor is a kind of experimental equipment integrating vacuum, distillation, reflux, stirring, constant temperature water bath or oil bath. This multifunctional vacuum constant temperature single-layer glass reactor can be used under constant temperature conditions. Biochemical reactions and synthetic reactions. The single-layer glass reactor is entirely a fully enclosed system. A circulating water vacuum pump can be used to generate a vacuum to draw in various liquids and gases. It can also be refluxed or distilled under different temperature conditions.
F-2L single layer glass reactor product details:
F-2L single layer glass reactor features:
The high borosilicate material used in the glass reactor has excellent physical and chemical properties, can meet the experimental requirements of -100 to 400 degrees Celsius, and has the characteristics of strong acid resistant materials. The material is only in contact with glass and tetrafluoroethylene during the reaction. , no cross-contamination;
The mechanical seal is used for mixing, which can maintain a good vacuum in the same kind of products in the market, and maintain high-precision sealing under working conditions;
Under the PTFE discharge, it can meet the no-angle stirring, and it can be quickly discharged without residue;
Frequency control gear motor, stable operation, large torque, automatic force increase, no spark, no noise, long life;
The support parts of the kettle body are made of high quality stainless steel tube and cast aluminum material, which is beautiful and generous, and the overall mechanism is stable;
The heating method is optional, and the water bath, oil bath and electric heating cover are convenient and practical;
The overall structure is scientific, novel, practical, beautiful, and leading the industry.
F-2L single layer glass reactor heating principle
The working principle of the single-layer glass reactor is that the heat transfer medium (water, oil) in the tank is directly heated by the heating coil (the electric heating sleeve directly heats the kettle body), and the heat transfer medium is passed through the kettle body to transfer the heat to the materials in the kettle. It is heated at a constant temperature and can provide agitation. The material is reacted in the reaction vessel and the evaporation and reflux of the reaction solution can be controlled.
F-2L single-layer glass reactor supporting equipment:
Water circulation vacuum pump: used to provide vacuum source to the reactor
Low temperature coolant circulation pump: can be used for condensing reflux and material forced cooling
Precautions for use:
1. Check the instrument carefully before use. Whether the glass bottle is damaged or not, and whether the interfaces are consistent, pay attention to light handling.
2. Wipe each interface with a soft cloth (can be replaced with a napkin) and apply a small amount of vacuum grease. (The vacuum grease must be covered after use to prevent the entry of sand.)
3. The interfaces of the glass reactor should not be tightened too tightly. It should be loosened regularly to avoid the long-term tight lock and cause the connector to bite.
4. Turn on the power switch first, then let the machine run from slow to fast. When the machine is stopped, stop the machine and turn off the switch.
5, the PTFE switch everywhere can not be tightened too much, easy to damage the glass.
6. Every time you use it, you must wipe off all kinds of oil stains, stains and solvents left on the surface of the machine with a soft cloth and keep it clean.
7. Loosen the PTFE switches after stopping, and the PTFE piston will be deformed when it is still working for a long time.
8. Regularly clean the sealing ring by removing the sealing ring and checking if there is dirt on the shaft. Wipe it with a soft cloth, then apply a little vacuum grease and reinstall it to keep the shaft and seal ring smooth.
9, the electrical part must not enter the water, it is strictly prohibited to get wet.
10, must purchase the original authentic accessories, free use of other accessories can cause fatal damage to the machine.
11. When making any repairs or inspections on the glass reactor, be sure to cut off the power supply and water source.
F-2L single layer glass reactor accessory products：
We have won the praise of the new and old customers with advanced production technology, reliable product quality, reasonable price, good reputation and considerate service.
The product packaging is complete, choose the most powerful logistics express, the delivery is fast, the appearance is beautiful and generous, to ensure that the product can be completely received by the customer.
After sales service
24 Hours online service for your consult.
Help choose right model,and a series of service,person,advise. Middle service
--Give you best offer
--Provide discount for many sets order
--Do customer's request:
--Choose payment term you convienent.
--Promptly production and delivery,inform you in time.
--Can provide invoice value as you like to decrease your tax. After sale service
--1 year warranty service and all life maintenance.
--Technical Egineer are avalible for oversea trainning.
--Free change for some parts
--Remote control technical consult
--Free installation DVD
GET A QUOTE